Changes

Jump to: navigation, search

ER-102

888 bytes added, 1 year ago
no edit summary
Panel Design Files: [http://www.orthogonaldevices.com/files/er-102-panel.zip?attredirects=0&d=1 er-102-panel.zip]
 
[[SYNC message on startup]]
 
If you get this message on the ER-102, then here is a checklist:
 
1. Check that the ER-101 is powering on. If properly powering up, the ER-101 will always perform an up/down sweep of the digit displays and then display the firmware version, regardless of whether it it conected to the ER-102. The usual culprit for an ER-101 not powering up is an incorrect setting of the 5V supply switch. Try setting it to REG.
2. Triple check that the orientation of the ER-101-to-ER-102 expansion cable is correct. The first page of the ER-102 manual has a detailed diagram for your reference.
3. If you get here, then it is highly likely that the ER-102 expansion cable was inadvertently plugged into the case power at some point and thus damaging the ER-102's ability to communicate with the ER-102. This requires a repair. Please contact me to setup that up.

Navigation menu