# ER-301/Sine Osc

## Contents

## Applications

- Synth voice
- Additive synthesis
- FM/PM synthesis
- LFO with sync capabilities
- Pass through a limiter to create a square wave.
- Waveshaper

## Description

## Parameters

### V/oct

Control Type | Has Sub-chain? | Sub-chain Parameters | Fader Scale |

Pitch | yes | transpose (-3600¢ to 3600¢) | logarithmic ratio |

This parameter is used to transpose the base frequency up or down according to an incoming modulation value that is V/oct calibrated (typically one of the inputs from the ABCD matrix). In other words,

**Failed to parse (MathML with SVG or PNG fallback (recommended for modern browsers and accessibility tools): Invalid response ("Math extension cannot connect to Restbase.") from server "https://en.wikipedia.org/api/rest_v1/":): {\displaystyle \text{f} = \text{f0} * 2 ^{\frac{x}{1200}} }**

where **Failed to parse (MathML with SVG or PNG fallback (recommended for modern browsers and accessibility tools): Invalid response ("Math extension cannot connect to Restbase.") from server "https://en.wikipedia.org/api/rest_v1/":): {\displaystyle x}**
is the value of this parameter (which is in cents). For example, if the base frequency (f0) is equal to 55Hz and this V/oct parameter is set to 2400¢, then the resulting frequency will be 220Hz (i.e. 2400¢ = 2 octaves which is 4x).

### f0

Control Type | Has Sub-chain? | Sub-chain Parameters | Fader Scale |

Gain/Bias | yes | gain (-10,000 to 10,000)
bias (10 octaves above and below 27.5Hz) |
frequency in Hertz |

This parameter sets the fundamental frequency that is subsequently transposed by the V/oct parameter. Modulating this parameter corresponds to (thru-zero) linear FM.

### phase

Control Type | Has Sub-chain? | Sub-chain Parameters | Fader Scale |

Gain/Bias | yes | gain (-10 to 10)
bias (-1 to 1) |
linear |

Sets the phase offset of the oscillator. Modulating this parameter is equivalent to PM (phase modulation). You can even set the f0 parameter to zero and put the oscillator completely under manual control via this phase parameter. This last case is also called waveshaping.

### feedback

### sync

### level

Control Type | Has Sub-chain? | Sub-chain Parameters | Fader Scale |

Gain/Bias | yes | gain (-10 to 10)
bias (-1 to 1) |
linear gain |

This parameter controls an internal bipolar linear VCA on the output of the unit. It behaves exactly the same as the level parameter of a Linear Bipolar VCA unit.